Winbond 25q32 Programmator

Winbond 25Q32 / SOIC 8 PIN Serial Flash ( size 209 mil ). Klyuch aktivacii nano antivirus. [A510] Package 10: Willem EPROM Programmer PCB50B+SOIC8 150mil Adapter+Extractor -36%.

Replaced winbond chip, is this correct? Hi, I have a Linux receiver that wouldn't flash properly, possibly due to a dodgy bootloader and thought I would try to replace the winbond chip, I have a GQ-4x programmer that I used to use for programming TSOP and luckily had an adaptor for it to fit the winbond.I have identified a replacement chip as 25Q32FVSIG. I found knocking around some old SPANSION S25FL016A chips that were very similar except for slightly different naming conventions to some of the pins, I programmed it with my bootloader after erasing chip and put it back on the PCB, the bootloader would become corrupted so I gave up with that and got the correct part which on ebay was W25Q32. I also tried to reprogram the original chip, firstly erasing it, then writing my bootloader to it, once the chip was back in the box I was in a semi up and running state but was still misbehaving. I know have the correct chip and it is a new chip, however, when I put it in my programmer I done a blank check on it and it failed as if to say it wasn't blank, I have now read the image and saved it. What I am unsure of is, am I supposed to erase the chip before I put my booloader on or do I write straight on top of it?, I'm thinking that when I erased the original chip I erased something from it that is not supposed to be deleted, like a header or something for it. Murder set pieces full movie. Som e solid advice would be greatly appreciated, until than I am going to attempt to write directly to the chip without erasing and put it in and see, if that doesn't work then I will erase it forst then write the bootloader and put in to pcb, in anycase, I have dumped the chip as soon as I received it and it certainly has something on it and I have it saved.

EDIT: can write to chip but will not verify, I don't think it will let me erase it, when I erase it it happens in a nano second and still reports as failed on blank check.

Hello CodeRush. Bricking my Asus G73JH as many before me has lead to this forum. Im now looking into this cheap programmer(CH341A), but i cannot download the software/man you've attached.

Both chrome and IE says its protecting me from malware or somthing along those lines. Is there another way to share this?(i've tried other sites aswell, all leads to malware protection.) I am currently unsuccessful reading my winbond w25q32bv chip using a rashberry pi and flashrom. I belive that flashrom should support my chips series, so i've ordered 3 new aftermarket chips of same model. I've connected all the pins, including /wp and /hold which gets 3.3v. Do you think getting one of these would be better than using flashrom/rpi? Hi, I bought an CH341A off of Amazon along with a blank Winbond W25Q64BV and transferred my bios serial and mac info using f4editor onto a fresh bios ver 3603 for the Asus P8z68 Deluxe Gen1 board.

I then plugged the bios chip into the socket of the CH341A just like in the illustration on the CH341A programmer tool and was able to verify chip type and erase chip, load image then program the chip BUT Verify fails and says contents don't match. I could even backup the burned image onto a file and read it correctly using the f4editor. Think this chip is safe to use? Note: My original bios chip is in perfect condition still in the motherboard. Just trying to learn how to flash these things for fun.