Nissan Consult 3 Software Crackers

Have got the alliance vi to work with Consult3 plus software. And make Consult III+ to run it with Ford VCM II interface. CarDaq Actica Passthru+ XS Python1B Nissan USB Diag Alliance VI And The obvious tool VI2 all these are the best to work with Consult 3 plus. Others will also work but maybe not as well.

Dec 3, 2018 - Nissan Consult 3 is a diagnostic software special for Nissan,support all. IProg Pro Plus iProg+ Crack Clone English Version Free Download. Before you install obd2tuning nissan Consult iii update software, you must uninstall any previous versions of the nissan consult 3 software. First, install obd2tuning nissan consult 3 software V9.20 (the image on the disk), then run Consult-III_V9.21.01.00.00_setup 3.

Young money bedrock download audiomack. The Ignition ON its not seen if you use VCM II I use AVDI and Ignition ON it is not seen too I read that no matter what j2534 tool you use the Ignition ON its not seen Probably, only if use Alliance VI2, but alliance vi is quite a bit more complicated to set up Here is thesetup of VCM II with Nissan Consult 3+. For ford VCMII In the Diagnostictool.ini put Ford-VCM-II Install the consult 3 plus Install your VCMII Manager and drivers.

In passthru 4.04 in reg edit and rename NISSAN_VI2 To something else change name Bosch Ford-VCM-II to NISSAN_VI2 Reboot computer and test it I tested it once with limited success. Attachment: [Diagnostictool.ini] Note 1: [alliance vi] The sonde alliance vi is the end for the sonde can clip RTL. Remplaced by sonde alliance vi but what is it.

Renault Aliance VCI = 100% Same with Nissan Consult III VCI Just & ONLY different name Note 2: [workable sw]Clone Consult III (who using patch) for to working with Nissan Consult III S/W, DID NOT working with Clip Software!!! It seems now Clip S/W needs NEW “Pill” for Clones. Original:How to get Nissan Consult III Plus work with Ford VCM2? Posted in Tagged,,,,,,, . I’ve been trying to get V46.11.00 to work with my usb link. Nexiq supports J2534 so i figured I would give it a shot.

I have a CF-19 Tough book which contains all me software for diagnostic. The CF-19 runs in deep freeze all the time to prevent any issues.

So I typically test software I acquire on my desktop first. Long story short I installed it on my Desktop edited the.ini file and got it to show connection to my nexiq. (Haven’t tested on a car because my desktop is in my living room). So I thought I was good even wrote a short tutorial to keep with my backups of software. I then installed on the CF-19. Edited the.ini. Expected to the the USB connection with the blue dot.

I installed both exactly the same. Im running identical versions Windows 7. There is quite a bit of software on my CF-19 I don’t if its interfering or not. Does anyone have any ideas. To be so close to it working but not able to test is frustrating.

Below I will put my short tutorial to show the steps I took and also maybe it will help others. (This is not my work just the steps I found on here).