Download Adams Pulsd Electric Motor Generator Manual

I have been working with a variation of the Robert Adams Pulse Motor now for the last few months. Having read all available literature on his over unity motor principles I wanted to build a replica of this type. I decided I would give it a damn good go and invest whatever resources were needed to have the best possible outcome. I set about purchasing the appropriate materials and constructed the prototype you see in the picture All the literature about Robert Adams and his motor speaks extensively about cold current reversal, amazing efficiency figures, and drive coils that were run cold while having very low resistances while at the same time, pulling almost no current from the source supply. My first attempts over the next few weeks obtained the complete opposite results. My drive coils were heating up to the point where they were melting the plastic they were wrapped in and current draw was so high that there was no way over unity could be achieved if I continued along this line of thinking.

Torino Italy. Torino Italy.

The motor appeared to be running fantastically, producing high RPM, fairly large amounts of torque and running so smoothly it was almost whisper quiet. As motors go it looked great, but electrically it was all going in the wrong direction.

I was sure Robert Adams was not a hoax and that his over unity claims must have had some validity because he has been around for almost 30 years. It also seems he was founding father of this pulse motor over unity phenomenon that so many other inventors and researchers claim success upon. The main one frustrating aspect: no one has clearly explained how and why these motors actually work so when you set about your replication there are plenty of diagrams and building examples to copy but no technical literature on how to electrically control the system and work within the magnetic field. Over the last few years, having built many a variation of a fixed magnet pulsed coil motor generator, I found the outcomes were always the same: great motors but free energy they were not! I still strongly believed a self-powered motor generator was possible. What was I doing wrong?

At this point I was becoming obsessed with trying to find the magical phenomenon that so many people had talked about. After having constructed my most sophisticated magnetic coil setup and getting undesirable results yet again, the only other place to start looking was in the timing and navigation of the magnetic field, so I constructed some complex electronics and set about investigating this area. With the aid of a small micro processor to calculate pulse width duration and exact pulse delivery times some amazing things started to become evident. By doing away with the crude reed switches and pot luck approach to switching the system on and off results started to improve.

Coil temperatures dropped drastically. Current flow dropped considerably. Battery life appeared to become almost infinite. I was amazed. Was it really that simple? Switching on the coil when the magnet situated on the rotor was in the exact location (as pictured below) and turning off the drive pulse at the exact time when no longer required were the crucial principles that achieved the long sought after phenomenon (i.e.

Better known as the cold current reversal technique) and it appeared that any slight deviation away from these electrical characteristics would render over unity impossible. I have continued working on and refining these principles. Ustanovochnij disk dlya skanera canon lide 110. Now, when looking back I realize how close I had come so many times in the years gone by but not been able to recognize the elusive over unity giant even when it was staring me in the face. I am writing this report in the hope that others will pick up this research and publish papers on these principles to make these ideas commonplace.

I am continuing this work and developing larger motor generators to power domestic appliances and even homes. I have a dream to be free of the grid and make power for my own home. I believe that now I can achieve this. All information is open source. Sounds really good. What was the time difference between the reed switching and the switching that worked?